All Rights Reserved. Copyright © 2010, Hitachi Software Engineering Co., Ltd.
4
3.Device Server SX-2000WG+ Setup
(1) Please connect SX-2000WG+ and the PC with one of the following methods:
(a) Prepare a network cross over cable to connect SX-2000WG+ and PC
(b) Prepare two network straight cables and an Ethernet hub to connect SX-2000WG+
and PC
(2) Reset SX-2000WG+ as shown below
Connect cross over network
cable to SX2000WG+ and PC
(a) Connect straight network cable to
Ethernet hub and PC
(b) Connect straight network cable to
Ethernet hub and SX-2000WG+
(a) Hold pressing the
reset button
(b) Plug the power cable
(c) Hold pressing the button until the LED
turns red, then release the button
To Next Page
Loading...
Need help?
General
