Hitachi YUTAKI RAS-2WHVRP1 - General Information; General Notes; Safety Information; Applied Safety Symbols

1 GENERAL INFORMATION
1.1 GENERAL NOTES
No part of this publication may be reproduced, copied, led
or transmitted in any shape or form without the permission of
Johnson Controls-Hitachi Air Conditioning Spain, S.A.U.
Within the policy of continuous improvement of its products,
Johnson Controls-Hitachi Air Conditioning Spain, S.A.U.
reserves the right to make changes at any time without prior
notication and without being compelled to introducing them into
products previously sold. This document may therefore have
been subject to amendments during the life of the product.
Hitachi makes every e󰀨ort to o󰀨er correct, up-to-date
documentation. Despite this, printing errors cannot be controlled
by Hitachi and are not its responsibility.
As a result, some of the images or data used to illustrate this
document may not refer to specic models. No claims will be
accepted based on the data, illustrations and descriptions
included in this manual.
2 SAFETY
2.1 APPLIED SYMBOLS
During normal heat pump system design work or unit
installation, greater attention must be paid in certain situations
requiring particular care in order to avoid damage to the unit, the
installation or the building or property.
Situations that pose a risk to the safety of those in the
surrounding area or to the unit itself are clearly indicated in this
manual.
A series of special symbols are used to clearly identify these
situations.
Pay close attention to these symbols and to the messages
following them, as your safety and that of others depends on it.
This appliance is lled with R32, an
odourless low burning velocity
refrigerant. If the refrigerant is
leaked, there is a possibility of
ignition if it enters in contact with an external
ignitions source.
! DANGER
• The text following this symbol contains information and
instructions relating directly to your safety.
• Not taking these instructions into account could lead to serious,
very serious or even fatal injuries to you and others.
In the texts following the danger symbol you can also nd
information on safety procedures during unit installation.
! DANGER
This symbol shows that this equipment uses a low burning
velocity refrigerant. If the refrigerant is leaked, there is a
possibility of ignition if it enters in contact with an external
ignition source.
RISK OF EXPLOSION
The compressor must be stopped before removing the refrigerant pipes.
All service valves must be fully closed after pumping down operation.
! CAUTION
• The text following this symbol contains information and instructions
relating directly to your safety.
• Not taking these instructions into account could lead to minor injuries
to you and others.
• Not taking these instructions into account could lead to unit damage.
In the texts following the caution symbol you can also nd
information on safety procedures during unit installation.
? NOTE
• The text following this symbol contains information or instructions that
may be of use or that require a more thorough explanation.
• Instructions regarding inspections to be made on unit parts or systems
may also be included.
Symbol Explanation
Before installation, read the installation and
operation manual, and the wiring instruction sheet.
Before performing maintenance and service tasks,
read the service manual.
For more information, see the installer and user
reference guide.
GENERAL INFORMATION
PMML0576 rev.0 - 06/2021
1
EN