S-23
•
Explosive separation of a tire and rim parts can cause seri-
ous injury or death.
• Do not attempt to mount a tire unless you have the prop-
er equipment and experience to perform the job. Have it
done by your authorized dealer or a qualified repair ser-
vice.
• Always maintain the correct tire pressure. DO NOT inflate
tire above the recommended pressure.
• When inflating tires, use a chip-on chuck and extension
hose long enough to allow you to stand to one side and
not in front of or over the tire assembly. Use a safety cage
it available.
• Inspect tires and wheels daily. Do not operate with low
pressure, cuts bubbles, damaged rims, or missing lug
bolts and nuts.
• Never cut or weld on an inflated tire or rim assembly. Heat
from welding could cause an increase in pressure and
may result in tire explosion.
521-E02A-0249
•
Travel reduction gears are under pressure.
• As pieces may fly off, be sure to keep body and face away
from AIR RELEASE PLUG to avoid injury.
• GEAR OIL is hot. Wait for GEAR OIL to cool, then gradually
loosen AIR RELEASE PLUG to release pressure.
503-E03A-0344
SA-344
SA-249
To Next Page
Loading...
Need help?
General
