HITEC Laser 4 User Manual

www.hitecrcd.com
www.hitecrcd.com
Austria, Belgium, Denmark, Finland,
France, Germany, Greece, Iceland,
Ireland, The Netherland, Italy, Spain,
Norway, Portugal, United Kingdom,
Luxembourg, Sweden, Switzerland
LASER 4&6
8
SYSTEM INTRODUCTION MANUALSYSTEM INTRODUCTION MANUAL
LASER 4&6 SYSTEM INTRODUCTION MANUAL
Made in Philippines
ATV
CH1 CH2
Digital Proportional FM Radio Control System
FM
V
-
t
a
i
l
M
i
xi
n
g
E
l
e
vo
n
M
i
xi
n
g
L
o
w
B
a
t
t
e
r
y
A
l
a
r
m
5. Product Service Information ( for USA & Canada only )
In the event you would require service to your radios, please send the parts to ::
Hitec RCD USA, Inc. Service Department
12115 Paine St.
Poway, CA 92064
Please include your name address and telephone number along
with a brief description of the failure or the work that you are requesting to be done.
6. Precautions
- Always turn your transmitter on first and off last.
- Never operate your system without first performing a proper range check.
- FCC regulation in the USA prohibits changing the crystal in your transmitter.
For channel changes send your system to an authorized service/repair center.
- Never fly around or over houses, people or power lines.
- Always charge your batteries before you fly.
- It's a good idea to check your receiver batteries with a tester like the Hitec
Power Mate II (part# 44110). This will verify the charge level in your receiver batteries.
- Always fly responsibly and respect the rights of others.
- Make sure your frequency is clear before turning on your system.
Congratulations again and have fun!
SYSTEM
INTRODUCTION
MANUAL
Made in Philippines
ATV
CH1 CH2
Digital Proportional FM Radio Control System
FM
V-
t
a
i
l
M
i
x
i
ng
E
l
e
v
o
n
M
i
x
i
n
g
L
o
w
B
at
t
e
r
y
A
lar
m
Made in Philippines
ATV EPA ATV
AIL ELEV THRO RUDD
FM
Digital Proportional FM Radio Control System
ELEV
D/
R
AIL
D
/R
V
-
t
ail
Mix
ing
Elev
on
Mix
ing
F
u
ll
Ch
a
r
ge
Made in Philippines
ATV EPA ATV
AIL ELEV THRO RUDD
FM
Digital Proportional FM Radio Control System
E
LE
V
D
/
R
A
I
L
D
/
R
V
-t
a
i
l
M
i
x
i
n
g
E
l
e
v
o
n
M
i
x
i
n
g
F
u
l
l
C
h
a
r
g
e

HITEC Laser 4 Specifications

General

Brand	HITEC
Model	Laser 4
Category	Control Systems
Language	English

Summary

Product Service Information

Precautions

Transmitter

Transmitter Features

Details common features for Laser 4 and Laser 6 FM transmitters.

Transmitter Layout

Diagram and labels for the LASER 4 front transmitter layout.

Transmitter Specifications

Technical details including power supply, current drain, output power, and modulation.

Servo Reversing Function

Explanation of the servo reversing feature on all transmitter channels.

Adjustable Travel Volume (ATV)

Adjusts servo travel for CH 1 & 2 (Laser 4&6) or CH4 (Laser 6).

Mixing Functions

Details V-tail and Elevon mixing capabilities for specific aircraft types.

Control Stick Adjustment

Adjusts the length of non-slip control sticks for user comfort.

Stick Lever Tension Adjustment

Adjusts the spring tension of control sticks for preferred feel.

Trim Lever Function

Used to correct or trim control surface tracking on aircraft.

Dual Rates

Allows adjusting servo throw on CH1 (Aileron) and CH2 (Elevator).

Landing Gear Switch

Operates a servo in CH5, typically for landing gear control.

Throttle End Point Adjustment (EPA)

Adjusts high and low throttle servo endpoints to prevent binding.

Battery Management

Transmitter/Receiver Battery Charging

Initial and subsequent charging guidelines for transmitter and receiver batteries.

Battery Spacer Usage

Proper use of battery spacers for securing battery packs.

Operation

Trainer System Setup

Instructions for setting up and using the trainer system.

Range Checking Procedure

Essential steps for performing a range check before operation.

Replacement Parts & Accessories