4
Warnings and Safety Notes
Warning
Caution
TipWarning
Note
Hitec Group USA, Inc. (Hitec RCD USA) will not be held responsible for any damages or injuries that may occur
by persons who fail to follow these warnings or who fail to properly follow the instructions in this manual.
Warning: Be sure to read this section for your own safety.
Tip: This section will help you maximize the performance of your charger.
Note: This section will provide more detailed explanations.
Caution: Be sure to read this section to prevent accidents and damage to
your charger.
These warnings and safety notes are of the utmost importance. You must follow these instructions for
maximum safety. Failure to do so can damage the charger and the battery and in the worst cases, may
cause a re.
NEVER LEAVE THE CHARGER UNATTENDED WHILE IT IS CONNECTED TO ITS POWER
SOURCE. IF ANY MALFUNCTION IS FOUND, TERMINATE THE PROCESS AT ONCE AND
REFER TO THE OPERATION MANUAL.
! The allowable AC input voltage is 100 - 240V AC
! The allowable DC input voltage is 11-18V DC.
! Keep the charger away from dust, damp, rain, heat, direct sunlight and excessive vibration.
! If the charger is dropped or suers any type of impact, it should be inspected by an
authorized service station before using it again.
! This charger and the battery should be put on a heat-resistant, non-ammable and
non-conductive surface.
! Never place a charger on a car seat, carpet or similar surface. Keep all ammable
volatile materials away from the operating area.
! Make sure you know the specications of the battery to be charged or discharged to
ensure it meets the requirements of this charger. If the program is set up incorrectly,
the battery and charger can be damaged.
! Fire or explosion can occur due to overcharging.
! Never attempt to charge or discharge the following types of batteries:
• A battery tted with an integral charge circuit or a protection circuit.
• A battery pack which consists of dierent types of cells (including dierent manufacturer’s cells).
To Next Page
