About PWS700T
B.4 Power Supply and Electrical Grounding
The three-position power connector accepts 24VDC only. The
unit's maximum power consumption is 10 watts at 24VDC. The
rating of fuse is 0.5A.
You must make sure that your 700T is properly connected to
earth ground. You must properly ground your 700T to prevent
it from radiating radio frequency noise.
If you connect a communications cable to your unit after
static electricity has built up or when the 700T and the
other device are on different grounds, the resulting
discharge could damage the electronics in either device.
Hitech Electronics Corp.
B-3
To Next Page
Loading...