QUICK START GUIDE
HITRON
CODA-4582/ 4682/ 4782
Connect to the network
Set up your wireless network
Read me
first!
1
ST EP
Check the Box Contents
Look in t he box and make sure you have t he f ol lowing:
2
ST EP
Connect to a Cable Outlet
Use a coaxial cabl e (not incl uded) t o connect t he device’ s CABLE
connect or t o a cabl e out let .
3
ST EP
Connect to a Power Outlet
Use t he power cord provided t o connect t he POWER port t o a power
out let .
5
ST EP
4
ST EP
User Configuration (Optional)
QUICK START GUIDE
CODA-4582/ 4682/ 4782 ETHERNET CABLE
POWER CORD
The Hit ron CODA-4582/ 4682/ 4782 is an applicat ion gat eway t hat provides
wired and wirel ess high-speed Int ernet access as wel l as opt ional MoCA
(Mult imedia over Coax Alliance) net working t o t he Et hernet -enabled
devices in your home f or a f ast and easy home ent ert ainment net work.
Use t he Et hernet cable provided t o connect one of t he LAN ports
t o an Et hernet -equipped device.
Connect to an Ethernet-Equipped Device (Optional)
Setup Complete
In a web browser, ent er 192. 168. 0. 1 in t he address bar f oll owed by
Username and Password, as below.
cusa dm in
pa ssw ord
7
ST EP
Congrat ulat ions! You have successf ully set up your CODA-4582/
4682/ 4782.
If you have any problems, see t he sect ion below f or help in
ident if ying t he cause.
IP Addresses
If t he CODA-4582 is successf ully connect ed t o t he net work (see LED Display)
but you cannot access t he Int ernet from a connect ed comput er, your
comput er’ s IP Address may be set up improperly. In your comput er’ s
net work set t ings, ensure t hat it is conf igured t o eit her receive an IP
address aut omat ical ly (recommended) or t hat it has a st at ic IP address in
t he 192. 168.0. 10~192. 168. 0. 254 range. For more inf ormat ion, consul t your
operat ing syst em’ s Help document at ion.
Connect with Wireless Devices (Optional)
6
ST EP
Connect your wireless devices wit h t he correct SSID and Passphrase.
If you have not changed t hem, t he def ault val ues are indicat ed on
t he st icker on t he back of t he unit .
Connect your wireless devices wit h t he WiFi
Prot ect ed Set up (WPS). Access t he configurat ion
int erf ace (see st ep 5), ent er t he Wireless page
t o enable WPS and set Encrypt Mode t o AES,
t hen press Save Changes.
Press t his but t on t o begin t he WPS Push-But t on
Conf igurat ion (PBC) procedure. Press t he PBC
but t on on your wirel ess cl ient s in t he coverage
area wit hin t wo minut es t o enabl e t hem t o j oin
t he wireless net work.
To Next Page
Need help?
General
