Hittite HMC-T2240 User Manual (English)

To Next Page

HMC-T2200 Synthesized Signal Generator Family

H M C-T2220/40

HMC-T2220/40

131547 Rev C - 02.1110

Programmer’s Manual

Installation, Operation & Maintenance Guide

for HMC-T2220 & HMC-T2240

Analog, Digital & Mixed-Signal ICs, Modules, Subsystems & Instrumentation

20 Alpha Road Chelmsford, MA 01824

978-250-3343 tel • 978-250-3373 fax • sales@hittite.com

Order On-Line at: www.hittite.com

Receive the latest product releases - click on “My Subscription”

ECN#CP110064

Table of Contents2
Introduction5
Quick Start5
USB Quick Start5
- Hyperterminal5
- Tera Term Pro Terminal Emulator5
Hmct2Xxxgui7
Gpib7
GPIB Quick Start7
GPIB Feature Set and Other Implementation Information7
Ethernet9
Ethernet Addressing9
- Ethernet Addressing: Turning DHCP on10
Ethernet Addressing: Static IP Address Assignment10
- Telnet Example10
Sockets11
- Example: Sockets with VISA Drivers11
Ethernet Security12
SCPI Command Reference12
SCPI Conformance Information12
SCPI Tips12
SCPI Command Reference13
Abort - Stop Sweeping13
- Example: Shut off a Continuous Sweep14
CLS - Clear Status14
- Example: Reset Status14
DCL - Device Clear - See SDC14
Diagnostic:compatibility[?] - Compatibility Mode14
- Example: Diagnostic:compatibility14
Diagnostic:macaddress15
- Example: Read Themac Address from a HMC-T224015
Display:enable[?] - LCD ON/OFF15
- Example: Preventing the Display from Changing at *RST16
Display:[Window:]Text:clear16
Display:[Window:]Text[:Data]16
- Example: Front Panel LCD Control16
Display:[Window:]Text:locate17
Display:[Window:]Text:state17
- ESE[?] - Event Status Enable17
  - Example: Errors Propagate to STB18
ESR? - Event Status Register18
- The Bits in the ESR19
  - Example: Detect an Error19
Format:sregister[?] - Decimal/Hex/Binary19
- Example: Format:sregister19
- Frequency - See [Source:]Frequency20
GET - Group Execute Trigger (GPIB Only)20
- PPE - Parallel Poll Enable (GPIB Only)20
  - Example: GPIB Parallel Poll with GET21
IDN? - Identify21
- Example: *IDN22
- Initiate:continuous[:All][?] - Start Sweeping22
  - Example: Start Continuous Sweep22
Initiate[:Immediate][:All] - Start a Single Sweep22
- Example: Start Sweep with Trigger23
IST? - Individual Status23
Output[:State][?] - RF Output On/Off23
- Example: RF On/Off State23
- Example: Output with Frequency and Power23
OPC - Operation Complete Command23
- Example: Operation Complete24
OPC? - Operation Complete Query24
- Example: Monitoring Sweep Status24
Power - See [Source:]Power24
PRE[?] - Parallel Poll Register Enable25
RST - Reset25
SDC - Selected Device Clear - Control Code26
- Example: Using Ctrl-D to Regain Control26
Source:]Frequency:center[?]27
- Example: Center and Span27
- Example: Center and Start27
- Example: Center Frequency Min/Max28
Source:]Frequency[:Fixed|:Cw][?] - Output Frequency/Frequency28
- Example: Frequency Commands28
Source:]Frequency[:Fixed|:Cw]:Step[:Increment][?] - Frequency Step29
- Example: Frequency Step29
Source:]Frequency:mode - Sweep Enable29
- Example: Frequency:mode[?]29
Source:]Frequency:resolution[?]29
- Example: Frequency Resolution30
Source:]Frequency:span[?]30
Source:]Frequency:start[?]31
Source:]Frequency:stop[?]31
Source:]Power:center[?]31
- Example: Setting up a Power Sweep with Center and Span32
Source:]Power[:Level][:Immediate][:Amplitude][?] - Output Power32
Source:]Power[:Level][:Immediate][:Amplitude]:Resolution32
Source:]Power[:Level][:Immediate][:Amplitude]:Step[:Increment][?]32
Source:]Power:span[?]32
Source:]Power:start[?]33
- Example: Setting up a Power Sweep with Start and Stop33
Source:]Power:stop[?]33
Source:]Sweep:count[?]33
Source:]Sweep:dwell[?]34
- Example: Dwell Time34
Source:]Trigger:slope Positive|Negative|Either[?]34
- Example: Trigger a Sweep on the Falling Edge35
Source:]Sweep:direction[?]34
- Example: Sweep Direction34
SRE[?] - Service Request Enable35
Status:operation:condition35
Status:operation Register Bit Definitions35
- Example: Operation Condition Status36
Status:operation:enable[?]36
Status:operation[:Event]36
Status:preset36
Status:questionable:condition36
Status:questionable Register Bit Definitions37
Status:questionable:enable[?]37
Status:questionable[:Event]37
Status:srqchar[?] - Service Request over USB37
- Example: Status:srqchar - Service Request Character38
STB? - Status Byte38
Status Byte (STB) Bit Definitions38
Sweep - See [Source:]Sweep39
System:communicate:ethernet:address[?] - IP Address39
- Example: Network Configuration with DHCP off39
System:communicate:ethernet:dhcp[?] - Automatic Configuration40
- Example: Network Configuration with DHCP on40
System:communicate:ethernet:gateway[?]40
System:communicate:ethernet:netmask[?]41
System:communicate:ethernet:port[?] - Socket Number41
System:communicate:gtlocal41
- Example: Go to Local41
System:communicate:gtremote41
- Example: Go to Remote42
System:error:all? - Read All Error Messages42
- Example: Read All Error Messages from Error Queue42
System:error:behavior42
- Example: Issue Error Messages Immediately42
System:error[:Next]43
- Example Read Error Message from Error Queue43
System:klock[?] - Front Panel Control Lock43
- Example: Local Lockout with Klock43
System:preset43
TRG - Trigger44
Example: *TRG - Trigger44
Trigger[:Sequence][:Immediate]44
Trigger[:Sequence][:Immediate]:Source[?]44
- Example: Trigger Source45
WAI - Wait for Operation (Sweep) to Complete45
- Example: *WAI to Wait for Sweep to Complete45

Need help?

Do you have a question about the Hittite HMC-T2240 and is the answer not in the manual?

Hittite HMC-T2240 Specifications

General

Brand	Hittite
Model	HMC-T2240
Category	Test Equipment
Language	English

Related product manuals

Hittite HMC-T2220

46 pages

Hittite HMC-T2240 User Manual

Table of Contents

Hittite HMC-T2240 Specifications

Related product manuals