Text your User Code followed by a space and the words GATES
CLOSE to your system.
Depending on the status of your system
you will receive one of the following
confirmation messages;
Gates Closed or
Gates Already Closed or
Gates Not Allowed
7
2222 is being used as a User code for illustrative purposes only
2222 GATES CLOSE
AUX ON Switches the auxiliary output on
AUX OFF Switches the auxiliary output off
ARM A Part sets the system (except zones set up for part-guard A)
ARM B Part sets the system (except zones set up for part-guard B)
SET A Same as ARM A (if you prefer to use the word “set”)
SET B Same as ARM B (if you prefer to use the word “set”)
GLOG Sends the last 7 log events of the GSM unit
SET ** Inhibits all open zones before setting the system
SET ## Inhibits all open tampers before setting the system
SET *3 Inhibits a specific zone (in this example zone 3)
SET *z3 This command is the same as set *3 above
SET *z03 This command is the same as set *3 above
SET *z003 This command is the same as set *3 above
SET #3 Inhibits a specific tamper circuit (in this example tamper 3)
SET #z3 This command is the same as set #3 above
SET #z03 This command is the same as set #3 above
SET #z003 This command is the same as set #3 above
SET *p80 Inhibits a specific point-zone (in this example point 80)
SET #p80 Inhibit a specific point-tamper (in this example pointer 80)
GATE Trips the GSM output assigned to pulse gate for the period
that is stated in the Output Pulse Menu
Note: Ask your installer if you are permitted to inhibit zones and tampers
Other commands
Note: in home-auto mode output 3 is now defaulted to Pulsed-Gate (PG). Sending the SMS command
re-programmed back to a toggled output
“gate” now triggers the output for 5 seconds. This time is programmable and the output can also be
Closing your gates
ABC
To Previous Page
Loading...
Need help?
General
