Open the lid of the cleaning tank and let the water pour down through the injection port.
12) Flush with running water from the rear opening of the dust bin at the end of operation.
If the sludge left inside the dust tank and vacuum hose is not cleaned up, it will lead to the
reproduction of microorganisms and bacteria and give off odor.
13) The dust tank cover shall be covered according to the original installation method and
installed back on the main engine.
Please make sure that the lid of the dust tank is properly closed.
Load the dust bin into the main machine.
If the dust tank is not properly loaded, the suction strength will be reduced.
Please pour out the sewage before it exceeds the full water level. If it continues to be used after
To Next Page
Loading...