Step 4
Continue sliding the pick under the perimeter of the back cover to fully separate
the clips and adhesive.
Step 5 — Remove the back cover
Lift and remove the back cover. During
reassembly:
Now is a good time to test your phone before sealing it up. Power it on and
check that it works. Power it back down before you continue reassembly.
If you're installing a new back cover:
Make sure you remove from the underside. ( Refer Snap -1 on next Page
)Use the flat end of a spudger to press the small cable above the wireless
charging coil into place over its alignment posts.( Refer Snap -2 on next
Page ).
To Next Page
Loading...
