Use one hand to grip the bottom corners of the frame and lift your phone slightly
off of your work surface (about 1/2 an inch or roughly 15 mm).
Make sure you're only gripping the frame, and not the screen and frame
together. Otherwise, the screen won't be able to separate.
With your free hand, use a SIM eject Tool - ( Refer Snap -6 in next
Page )to
gently
push down on the screen through the cutout in the
bottom corner of the frame. This should separate the screen,
causing it to fall onto your work surface. ( Refer Snap -7 in next Page )
Guide the screen cable through its cutout and lift the frame off the screen.
Set the frame down on a clean surface so the cameras are facing up.
To Next Page
