During reassembly:
Remove any tape or liners from the back of the screen—check the screen
cable and front facing camera cutout. ( Refer Snap -8 in next Page. )
Hold the frame in one hand and your replacement screen in the other.
Thread the screen cable through its cutout on the
front
of the frame and press
the screen into place so it's flush in the frame. ( Refer Snap -9 in next Page
)
Lay your phone screen side down on a soft cloth, making sure the screen
doesn't detach from the frame.
Simultaneously press down on all four corners of your phone to fully seat the
screen in the frame.
Use a T3 Torx screwdriver to install four screen screws in the corners of the
frame— this ensures that the screen doesn't detach from the frame during
reassembly.
If the screws aren't catching, double-check that the screen is fully seated.
To reassemble your device, follow these instructions in reverse order.
To Next Page
