Lift and remove the back cover. During
reassembly:
Now is a good time to test your phone before sealing it up. Power it on and
check that it works. Power it back down before you continue reassembly.
If you're installing a new back cover:
Make sure you remove all liners from the underside. ( Refer Snap - 1 in next Page )
Use the flat end of a spudger to press the small cable above the wireless
charging coil into place over its alignment posts. (Refer Snap -2 in next
Page)
Place the back cover onto the frame and firmly squeeze around the perimeter
to reengage all the clips.
To Next Page
