Instruction Manual © Gebr. Holtho, www.hmf-shop.de, info@hmf-shop.de 3
English
Instruction Manual
Art.-No.: 2030-11, 2048-11, 2071-11, 2133-11
EN
Key Safe with Electronic Lock
1. Bolts
2. Reset Button
3. Battery Compartment
4. Knob (Master Key)
5. Emergency Lock Cover
6. Green Light
7. Red Light
8. Yellow Light
9. Conrming Button
10. Power Supply
(4 x AA Batteries)
1. Opening the vault for the rst time
1.1 When opening for the rst time, please use the enclosed emergency key. Remove the emergency lock
cover (5) and unlock the lock counterclockwise.
1.2 Rotate the knob (4) clockwise to open the door.
2. Inserting the batteries
2.1 Open the door and remove the battery compartment cover (3).
2.2 Insert 4 x AA batteries, observing polarity.
WARNING! If the red and green LEDs light up simultaneously, the batteries are low and fresh batteries should
be inserted.
3. Storing the personal code
Once the safe door is opened and the batteries are inserted, you can store your personal code (3 - 8 digitis).
3.1 Press the reset button (2) on the inside of the door.
3.2 Now start entering your personal code (3 - 8 digits) as soon as the yellow LED lights up. Conrm
the entry with “A” or “B”. The following two beeps conrm the storing of the new code.
3.3 If the yellow LED ashes and three beeps follow, the new code has not been saved successful.
Please repeat the procedure.
4. Opening the vault
4.1 Enter your stored code (3 - 8 digits). When you press a button, a beep sounds and the yellow LED
ashes.
4.2 Conrm the entry with “A” or “B”. The green LED lights up.
4.3 Rotate the knob (4) clockwise and pull the door to you within 5 seconds.
WARNING! The preset code is “159”. You can use this if problems occur with the electronic lock. These are
indicated by three ashes of the yellow LED on the electronic lock.
WARNING! DO NOT KEEP EMERGENCY KEYS IN VAULT!
If the batteries are empty, the vault can only be opened with the emergency keys.
g. 1
g. 3
g. 2
!
WARNING
To Next Page
Loading...