Hobart 4732 - MACHINE HEIGHT AND LEG OPTIONS

– 3 –
LEGS (FIGS. 1 & 2)
The four leg assemblies are packed in a separate
carton for shipment. The standard legs (5
3
/8" high)
allow the rim of the feed pan on the table model to
be 27" above the table surface. These legs have
neoprene feet and require assembly. To assemble
5
3
/8" high legs: Slide the Leg Stud through the Leg End
Cap and the Leg; then thread the Leg Stud into the
base of the machine (Fig. 2). Do not overtighten; the
legs need only be hand-tight. Thread the Neoprene
Foot into the Leg Stud (Fig. 2).
Floor model choppers are equipped with optional 18" or 21" legs. Each Leg is one piece and threads into
the base of the machine at the four corners. These Legs can be adjusted by threading the Feet in or out
as necessary (Fig. 2) to level and stabilize the chopper.
Fig. 1
Fig. 2
PL-56170
LEG (18" or 21")
LEG
LEG END CAP
LEG STUD
NEOPRENE FOOT
FOOT
34"
INSIDE
5"
8-1/2"
4-3/8"
33-5/16"
DIM "B"
DIM "C"
DIM "A"
15-1/4"
4-1/16"
21"
INSIDE
17-3/8"
1-3/8"
20-1/8"
12-1/2"
1-5/16"
MACHINE HEIGHT FOR LEG OPTIONS
LEGS DIM "A" DIM "B" DIM "C" MODEL
5-3/8"
STD
10-3/4"
5-3/8"
4732
4732A
18"
OPT
23-3/8" 18"
4732
4732A
21"
OPT
26-3/8" 21"
4732
4732A
00-088182
ACCESS FOR
ELECTRICAL
POWER CONNECTION
WARNING
ELECTRICAL & GROUNDING CONNECTIONS MUST COMPLY WITH
THE APPLICABLE PORTIONS OF THE NATIONAL ELECTRICAL
CODE AND/OR OTHER LOCAL ELECTRICAL CODES.
(1-1/16 DIA HOLE)
FOR 3/4" TRADE SIZE CONDUIT
ELECTRICAL CONNECTION HOLE
ON/OFF SWITCH MAY BE
MOUNTED FOR RIGH HAND
OR LEFT HAND OPERATION
27"
27-3/8"
39-5/8"
40"
42-5/8"
43"