03-6
Hints for 1 and 2:
Remove the surface coating of the coupling ball
with sandpaper (200-240 grain) and clean with a
thinning solvent or spirit.
for 3:
Polish or clean dirty or damaged coupling balls.
for 4:
Clean the surface of the friction elements with
sandpaper (200-240 grain) and then clean with
petroleum ether or spirit.
Noises
Certain noises can occur during the course
of the drive; these noises, however, have no
inuence on the operative effectiveness of the
tension ball coupler.
Possible causes of these noises can be:
1. a dacromet-coated coupling ball on the
base vehicle,
2. a galvanized coupling ball on the base
vehicle,
3. a damaged or dirty coupling ball on the base
vehicle,
4. dirty friction elements on the tension ball
coupler.
To Next Page
Loading...
Need help?
General
