EasyManuals Logo

Hobby 610 UL Excelsior Operation Guide

Hobby 610 UL Excelsior
114 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #56 background imageLoading...
Page #56 background image
06-7
6.5 Truma-Vent-Gebläse
1
3
1
42
1
Bild 1
Bild 2
Bild 3
The camper is equipped with an air circulation
unit (equipment varies according to each mo-
del). This unit distributes the warm air from the
heating element throughout the entire interior.
The desired level can be adjusted by the turning
know. The turning knob (1) is located on the ca-
sing of the heating element (Fig. 1 and 2).
Operation with 12 volt automa-
tic torque
Adjustment by hand:
Set the switch to position (1) (Fig. 3).
Adjust the desired level via the turning knob
(4).
To turn off:
Set switch to position (2).
Automatic operation:
Set switch to position (3). The level adjusts it
self continuously to the corresponding release
of warmth by the heating element. The high
est level can be limited by the turning knob.
The adjustment between this value and the
slow-running setting takes place automatical
ly.
If less air is circulated or the noise
from the blower increases, this
means that the ventilation wheel is
dirty. As a rule, the heating elment
casing and vacuum pipe should be
removed from the heating element
approximately every 500 hours of
operation and the ventilation wheel
should be gently cleaned with a thin
brush.

Table of Contents

Other manuals for Hobby 610 UL Excelsior

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Hobby 610 UL Excelsior and is the answer not in the manual?

Hobby 610 UL Excelsior Specifications

General IconGeneral
BrandHobby
Model610 UL Excelsior
CategoryMotorhomes
LanguageEnglish

Related product manuals