Remark: if the motor suddenly stops when your model airplane are flying, you shall immediately push the
pull rod of throttle to the lowest position and then push to the high position. Then the motor will restart. You
shall land the model airplane immediately with throttle controlled with a lower position.
Please pay attention to the following safety information when using.
● Never disassemble any electro components in the ESC by yourself, or permanent damages or lost of
information will occur.
● Check the setting of receiver. Do not install propeller or small driving gear on motor if you haven’t confirm
that the setting of receiver is correct when test the ESC and motor for the first time.
● Do not use cracked or broken battery pack.
● Do not use battery pack easily get overheat.
● Do not use short-cut battery.
● Do not use cable insulation material against standards.
● Do not use cable connector against standards.
● The number of battery or servo system shall not exceed the rules for ESC.
● The voltage of battery shall not exceed the scope of working voltage of ESC.
● Pay attention to the polarities of battery. Wrong polarities will damage the ESC.
● Be sure that the ESC will not use in manned craft or other manned machines.
● Do not place the ESC in moist or over exposure.
● Do not take out battery when the motor is working, for the generated large peak current will damage the ESC.
● Do not pack anything outside the ESC. Install the ESC in places with good ventilation and heat dissipation as
far as possible.
The second group
sound means the
situation of brake.
(One beep to the
open of brake, two
beeps to the close of
brake). The
preparation of the
ESC is completed.
The first group
sound means that
the number of
battery in battery
pack connected to
the ESC (three
beeps to three
batteries, four beeps
to four batteries.)
Turn on the remote
control and push the
pull rod of throttle
to the lowest
positionp
first time.
To Next Page
Loading...
Need help?
General
