Name: Hobie Adventure Island
Brand: Hobie
Rating: 4 (1 reviews)

To Next Page

To Previous Page

16. Drill a hole in the dotted location with a 5/16” drill bit

17. Insert one of the two the small

length of rigid tube into the hole and

press the black ﬁtting at the end of the

tube into the hole. It will be a tight ﬁt,

so you may need to give it a couple

taps with a hammer to get it into the

hole.

15. Locate the cleat in the kit and place it on the right side of the

kayak along the forward edge of the map pocket. Center the middle

of the cleat to the point of the corner of the rails. Draw a small dot

on the kayak to locate a drilling location. The hole location should be

slightly below the top of the cleat jaws.

Drill

Location

14c. Once the loops are held down with the screw, leave these lines alone for a bit and ﬁnish up the

instructions below.

14a. Place the loop around the screw and thread the screw back into

the rudder.

14b. Follow the sample procedure with other screw and control line.

Questions and Answers:

Need help?

Do you have a question about the Hobie Adventure Island and is the answer not in the manual?

Hobie Adventure Island Specifications

General