4
1/8”
3mm
Metal clips
1
Mount your transducer to the
Lowrance Ready Plate located
on the underside of the kayak.
You will need to remove the 3
screws that attach the plate
to the hull and then use the
Lowrance Ready hardware
that comes with the boat in the
owner’s manual to install the
transducer to the plate.
Mounting the Transducer
Once the transducer is installed, feed the transducer wire though the scupper
hole and screw the plate back in to place. You should now have the transducer
cable accessible in the cockpit of the kayak.
To Next Page
Loading...
Need help?
General