HOFFEN ASSC-H002 - Troubleshooting Common Issues

EN
[30]
BAGLESS VACUUM CLEANER
appliance’smainbodyandopenitbyholdingitwithonehandandwith
theotherhandturnthelid,bythehandle(G),totheanti-clockwise
direction,untilarrowonthelidisalignedwiththeopenpadlocksymbol
printedonthedustcontainer(H).Thenliftthelidandyouwillndthe
HEPAlter(Q)ttedtothelterrack(O).Toremovethelter(Q),turn
itanti-clockwise(followthearrowmarked“UNLOCK”).
• RinsetheHEPAlter(Q)andlterrack(O)withwarmrunningwater,
withoutusinganydetergents.Afterrinsingthem,allowthelter(Q)
andtherack(O)todrycompletely.
Important:thelter(Q)andlterrack(O)mustnotbeassembledon
theappliancewithoutbeingcompletelydried.
• Aftercleanedanddried,insertthelterrack(O)intothedustcontainer
(H)andinserttheHEPAlter(Q)intotherack(O).Thenrotatethelter
(Q)clockwisetoassembleit(followthearrowthatindicates“LOCK”).
• Assemblethelidonthedustcontainer(H)byrotatingitclockwiseuntil
thearrowonthelidisalignedwiththelocksymbolprintedonthedust
container(H).
• Replacethedustcontainer(H)ontheappliancebodyandmakesure
thatitisproperlyseated.
TROUBLESHOOTING
Duringuse,ifanyirregularitiesaredetectedontheappliance’soperation,
check the below table to understand the causes and solutions. If it is not
possible to detect the cause, please contact the store where the appliance
was bought.
Problem Possible Cause Solution / Hint
The appliance does
not switch on when
connected to the wall
socket.
Theplugisnottted
correctlyintowallsocket.
Fittheplugcorrectlyinto
the wall socket.
The wall socket is
damaged.
Check if the wall socket
is damaged, and connect
the appliance to another
thatworksproperly.