EN
[36]
CORDLESS STEAM IRON
before use.
• Remove any protective lms or stickers from the soleplate (N) and from
the appliance’s main body.
• Clean the soleplate (N) with a soft cloth to remove any manufacturing
residues.
Filling up the water tank
• Make sure that the appliance is unplugged from the wall socket, that
the temperature selector knob (K) is in the minimum position “MIN”
and that the steam control button (F) is also in the o position “ ”.
• Place the iron on the vertical position, open the water-ll cover (E),
tilt the iron forward at an angle of approximately 45° and pour water
to ll the tank (C) until it reaches the maximum level mark, marked
with “MAX” inscription. Make sure it does not exceed the “MAX” mark
indicated at the tank. For this purpose, you can use the water measuring
cup (M) supplied with the appliance.
• After lling the water tank, close the cover (E). The iron is now ready
to be used.
Operation
• Place the iron on the base (A) and connect the base (A) to the mains
• Select the appropriate temperature on the temperature button (K) in
accordance with the fabric type to be ironed.
• The blue LED light on the base (A) illuminates indicating that the base
is connected to the power source. The indicator lights of appliance
switched on and temperature reached (J) light up, the rst light ashes
indicating that the appliance is switched on “ ” and as soon as the
selected temperature is reached, the “ ” lamp will light up.
Note:
Note:
When unpacking the appliance it can happen that it contains traces of
water. This means that the appliance was submitted to quality control
tests at the factory, before being released to marketed.
It is possible to use this appliance with tap water or a mixture of 50%
tap water and 50% of distilled water.
Do not use hot water, perfume, vinegar, gum, decalcifying products or
other chemical agents in the water tank.
To Next Page
Loading...