HOFFEN FGVTK-H014 - Page 42

EN
[42]
CORDLESS STEAM IRON
The appliance heats
too much.
The temperature
selector knob (K)
was set to a too high
temperature for the
fabric to be ironed.
Set the temperature
selector knob (K) to
a lower temperature,
more suitable for the
fabric to be ironed.
The appliance does
not produce enough or
any steam at all.
The water tank (C)
is empty or does not
have enough water.
Fill the water tank (C).
See the instructions
described on "Filling
up the water tank”
section.
The steam control
button (F) is in the o
position.
Set the steam
output on button (C)
according with the
fabrics to iron.
The appliance does
not produce enough or
any steam at all.
The appliance has not
reached the required
temperature.
Set the temperature
selector knob (K) to
the zone indicated
with the symbol “
” and “MAX” and wait
until the appliance
warms up.
The steam vents at
the soleplate (C)
are clogged with
limestone.
Use distilled water
and a wood toothpick
to unclog the steam
vents in the soleplate
(C). Proceed to
the self-cleaning to
remove limestone and
minerals accumulated.
See the instructions
in "Self-cleaning
function" section.
No steam boost
output.
You did not wait the
recommended period
of time between each
pressing of the button
(I).
Wait 1 minute
between each pressing
of the button (I) and
then use this function
again. Never repeat
this procedure more
than 3 consecutive
times.