[41]
EN
CORDLESS STEAM IRON
• If the cloth material and the correct temperature to iron are unknown,
it is recommended to test ironing on a small part on the reverse side.
Start with a low temperature and increase gradually.
• For delicate fabrics such as silk, wool, velvet, etc. it is recommended to
iron on the cloth’s reverse side or use a cloth between the fabric and
the iron, to prevent shinny patches.
• It is recommended low temperatures for clothes with unusual nishes
(sequins, embroidery, plush, etc.).
• If the fabric is a mixture of several bres (for example 40% cotton and
60% synthetic), place the temperature selector knob (K) to the lower
temperature level.
• Never iron fabrics with stains since the heat marks the stains on the
fabric, making them dicult to remove.
• It is recommended a lower temperature when starch is used on the
fabrics and when ironing without steam. The excessive heat burns the
starch and forms yellow stains.
• To avoid shinny patches on velvet fabrics, iron them only in one direction
(the direction of bre).
• Many fabrics become easier to iron if they are not completely dry. For
example, silk should be ironed when still moist.
TROUBLESHOOTING
• During use, if any irregularities are detected on the appliance’s operation,
check the below table to understand the causes and solutions. If it is
not possible to detect the cause, please contact the store where the
appliance was bought.
Problem Possible cause Solution / Hint
The appliance is
turned on but does
not heat up.
The temperature
selector knob (K) is
set to minimum.
Set the temperature
selector knob (K)
to the intended
temperature.
Problems with the wall
socket.
Connect the appliance
to a wall socket in
good conditions.
To Next Page
Loading...