3
32
Danger of explosion! Batteries must not be dismantled, put into re or short-cir-
cuited.
Do not disassemble, open, or damage the battery housing.
Do not subject the battery to mechanical shock.
If any acid from the batteries comes into contact with your hands, rinse them
under running water. If any acid gets into your eyes, contact a doctor. Battery
acid can cause irritation or burns.
7.4 OPERATION
1. After assembling the device, press the on/off button and start vacuuming.
2. When it is switched on, the device operates at high suction power.
3. After pressing the +/- button, it switches to low suction power. Press +/- again
to switch to high suction power.
4. To use the wet cleaning function – ll the water tank with cold or lukewarm
water through the opening in the tank top part. Close the opening with the
dedicated plug (included). Put the cloth mop on the water tank bottom. Then
connect the tank with the device (there are magnets in the tank that will hold
it in position), press the “open” button and use the device as a mop. The mop
function does not require the vacuum cleaner to be operating.
CAUTION! The vacuum cleaner must not suck in water! It must not be used to
vacuum up water. Observe caution so as not to vacuum ooded surfaces. This
function is not intended for carpet washing, but for oor cleaning.
5. When nished, press the “CLOSE” button on the water tank, then switch off the
device by pressing the on/off switch.
To Next Page
Loading...
