Holden Trailblazer Owner Manual (Australia-Localizing-Australia-12333016) -
2019 - crc - 3/2/18
Instruments and Controls 79
Flashes to indicate that the Descent
Control System (DCS) is activated,
reducing the vehicle's speed. This
will occur at speeds between
approximately 4 km/h and 30 km/h.
Illuminates after pressing the
5
button to indicate that the system is
enabled if vehicle speed is below
50 km/h.
See Descent Control System (DCS)
0 207.
Lane Departure Warning
(LDW) Light
If equipped, @ located in the centre
of the instrument cluster illuminates
briefly while starting the engine. If it
does not illuminate, have the vehicle
serviced.
@ illuminates green when LDW is
on and ready to operate.
@ changes to amber and flashes to
indicate that a lane marking has
been crossed without using a turn
signal in that direction.
See Lane Departure Warning (LDW)
0 219.
Vehicle Ahead Indicator
If equipped, V illuminates green
when a vehicle is detected ahead.
The indicator will display amber
when you are following a detected
vehicle ahead too closely.
See Forward Collision Alert (FCA)
System 0 210.
Electronic Stability
Control (ESC) Indicator
Light
.
The
G warning light illuminates
for a short time when the ignition
is turned on to show that the
light is working.
.
The light flashes while driving, to
show that the ESC is actively
helping the vehicle with road grip
and stability.
.
If the light illuminates or does
not extinguish while driving,
contact a Holden Dealer
immediately.
.
See Driver Information Centre
(DIC) 0 82 and Electronic
Stability Control (ESC) 0 206.
Electronic Stability
Control (ESC) Off Light
.
The
g warning light illuminates
for a short time when the ignition
is turned on to show that the
light is working.
.
If the light does not illuminate,
contact a Holden Dealer.
.
g illuminates when the ESC is
deactivated.
.
See Driver Information Centre
(DIC) 0 82 and Electronic
Stability Control (ESC) 0 206.
To Next Page
Loading...
Need help?
General
