What to do if my HOLLAND LIFT N-195EL12 Scissor Lifts cannot be turned on?
If your HOLLAND LIFT Scissor Lift won't turn on, check these potential causes: * Ensure the main switch is turned on. * Verify the emergency stop button hasn't been pressed. If it has, pull it out and wait 10 seconds. * Check for a short circuit or blown fuse and replace the fuse if necessary.
Why the hydraulic pump motor runs, but the HOLLAND LIFT N-195EL12 Scissor Lifts does not function?
If the hydraulic pump motor runs but your HOLLAND LIFT Scissor Lift isn't functioning, it could be due to: * A malfunctioning hydraulic pump, preventing pressure buildup in the hydraulic system; in this case, contact the technical service department. * Low oil level in the hydraulic system; top up the hydraulic system. * A broken hydraulic pump; replace the hydraulic pump.
What to do if the platform cannot be raised or lowered on HOLLAND LIFT Scissor Lifts?
If the platform of your HOLLAND LIFT Scissor Lift cannot be raised or lowered, it might be because the platform has been overloaded, activating the overload safety device. Reduce the load on the platform or follow the emergency descent procedure.
Why are the red segments of the LED bar indicator flashing on HOLLAND LIFT N-195EL12 Scissor Lifts?
If the red segments of the LED bar indicator are flashing on your HOLLAND LIFT Scissor Lift, it means the battery voltage is too low. Charge the batteries.
General| Drive Type | Electric |
|---|---|
| Overall Width | 30 in |
| Overall Length | 90 in |
| Platform Width | 30 in |
| Gradeability | 25% |
| Platform Height | 195 in |
| Max Working Height | 195 in |
| Working Height | 195 in |
| Tire Type | Solid |
To Next Page
