What to do if my HOLLAND LIFT Scissor Lifts cannot be turned on?
If your HOLLAND LIFT Scissor Lift won't turn on, check these potential causes: * Ensure the main switch is turned on. * Verify the emergency stop button hasn't been pressed. If it has, pull it out and wait 10 seconds. * Check for a short circuit or blown fuse and replace the fuse if necessary.
Why the hydraulic pump motor runs, but the HOLLAND LIFT Scissor Lifts does not function?
If the hydraulic pump motor runs but your HOLLAND LIFT Scissor Lift isn't functioning, it could be due to: * A malfunctioning hydraulic pump, preventing pressure buildup in the hydraulic system; in this case, contact the technical service department. * Low oil level in the hydraulic system; top up the hydraulic system. * A broken hydraulic pump; replace the hydraulic pump.
What to do if the platform cannot be raised or lowered on HOLLAND LIFT Scissor Lifts?
If the platform of your HOLLAND LIFT Scissor Lift cannot be raised or lowered, it might be because the platform has been overloaded, activating the overload safety device. Reduce the load on the platform or follow the emergency descent procedure.
Why are the red segments of the LED bar indicator flashing on HOLLAND LIFT HL-190 E12?
If the red segments of the LED bar indicator are flashing on your HOLLAND LIFT Scissor Lift, it means the battery voltage is too low. Charge the batteries.
What to do if HOLLAND LIFT HL-190 E12 cannot be driven with a raised platform?
If your HOLLAND LIFT Scissor Lift cannot be driven with a raised platform or the platform cannot be raised, it's likely that the maximum tilt has been exceeded, activating the tilt safety device. Lower the platform and ensure the scissor lift is on a level surface.
Why the scissor lift brakes do not engage in HOLLAND LIFT?
If the brakes on your HOLLAND LIFT Scissor Lift are not engaging, consider the following: 1. Ensure the brake system was re-engaged after towing. If not, re-engage the brake system. 2. Check if the brake packet is correctly adjusted. Readjust the brake packet if necessary. 3. The multiple disc brake may be worn, requiring a new brake packet.
Why HOLLAND LIFT HL-190 E12 Scissor Lifts cannot be driven at the fast speed?
If your HOLLAND LIFT Scissor Lift cannot be driven at the fast speed, it is because the platform is at a height of more than 3 meters. Lower the platform to a height of less than 3 meters.
Details procedures for emergencies, including emergency stop and contact with high-voltage power lines.
Provides comprehensive safety guidelines for normal use, maintenance, electrical, and hydraulic systems.
Details emergency stop, dead man's switch, safety prop, and protective guardrail functions.
Provides a general overview of the control locations on the scissor lift.
Describes the control box, its plug-in connection, and its use on platform and carriage.
Details all the buttons, indicators, and the joystick on the control panel.
Explains the function and operation of the main power switch.
Lists necessary preparations before operating the scissor lift.
Details the step-by-step process for starting the scissor lift.
Provides instructions for safely switching off the lift and checks for platform during transport.
Lists components, actions, and frequencies for routine maintenance tasks.
Illustrates lubrication points and lists specific bolt tightening torques.
Details procedures for safety prop installation, hydraulic topping up, lubrication, and tilt device check.
Outlines the procedure and criteria for inspecting the scissor mechanism.
General| Brand | HOLLAND LIFT |
|---|---|
| Model | HL-190 E12 |
| Category | Scissor Lifts |
| Language | English |
To Next Page