Need help?Do you have a question about the Hollis Prism 2 and is the answer not in the manual?
General| Function | PPO Display 2 |
|---|---|
| PPO range 2 | 0.1 ata to 1.9 ata |
| PPO resolution 2 | 0.1 ata |
| Crush Depth Limit | 30 ata (~290 msw) |
| Operating Temperature Range | +4 °C to +32 °C |
| Short-Term (hours) Temperature Range | -20 °C to +50 °C |
| Long-Term Storage Temperature Range | +5 °C to +20 °C |
| Power source | Supplied by DiveCAN® bus. 3.0 V to 10.0 V |
| External Connector | 5-pin DiveCAN® connector (male pins) |
| Cable Length | 1 m |
Weight and Dimensions| Weight | 0.08 kg |
|---|---|
| Size - body only (L X D) | 84 mm X 13.25 mm |
Essential safety precautions for operating the rebreather.
Hazards and precautions related to high-pressure oxygen use.
Information on the rebreather's design, materials, and testing standards.
Warnings related to the rebreather's electronic control system.
Safety procedures for handling the caustic CO2 absorbent.
Warnings and advice regarding the rebreather's software functions.
Information and warnings about the CO2 scrubber system.
Guidance on proper weighting for buoyancy and trim.
Specifies the type of batteries required for the rebreather's operation.
Discusses the foundational principles behind the PRISM 2 rebreather.
Introduces the rebreather's components and gas path layout.
Provides guidance on the proper handling and maintenance of oxygen sensors.
Details the function and operation of the PID control loop for oxygen.
Guides the user on how to properly adjust the rebreather for optimal fit.
Discusses factors affecting diving stability and trim with the rebreather.
Explains the procedure for cleaning and preparing O-rings for rebreather assembly.
Details the process for filling the CO2 scrubber with absorbent material.
Emphasizes the importance of checklists for rebreather setup and operation.
Outlines a comprehensive checklist for inspecting all rebreather components.
Provides a step-by-step guide for assembling the rebreather system.
A basic checklist for pre-dive operational checks and setup verification.
An advanced operational checklist with detailed prompts for setup and checks.
A comprehensive operational checklist with step-by-step instructions.
A checklist for post-dive procedures, cleaning, and maintenance.
Teaches how to safely descend while managing loop PO2 and buoyancy.
Details the buddy-assisted check to ensure loop integrity underwater.
Explains the procedure for operating the Dive Surface Valve and Bail-Out Valve.
Guides on manually adding diluent to control loop volume and PO2.
Focuses on achieving and maintaining neutral buoyancy in closed-circuit diving.
Covers the procedure for using an external bailout system during dives.
A list for tracking the completion of various diving skills and drills.
Outlines required annual service and user maintenance tasks.
Details the regular cleaning procedures for various rebreather components.
Explains how to clean counterlungs and drain any collected fluids.
Provides instructions for maintaining the BCD, Wing, and Harness.
Explains different grades and specifications of oxygen used in diving.
Lists approved cleaning agents, batteries, and maintenance products.
Details technical specifications like scrubber duration and sensor ranges.
Provides definitions for technical terms used in the manual.
To Next Page
