8
The pump can be shut down after completion of the work.
* Close the tool(s) being operated with the pump. (Partially re-open the tool to relieve any
pressure)
* Check that the pump relief valve is in its "neutral" position. (before uncoupling hoses).
* Press the “ENGINE STOP” button to stop the engine.
* Close the fuel valve.
* Remove any dirt from the couplings and the dust caps to prevent penetration into the hydraulic
system.
* Take the dust caps apart and place them on the power unit’s couplings.
5.2.7 Cleaning and storage
Clean the unit and any accessories used before storage.
* Clean all quick-action couplings. Ensure that the dust caps are installed
* Check the pump for external damage and/or oil leakage.
* Always store the pump in a horizontal position.
* Ensure that the pump cannot tilt during transport. This can cause leakage of hydraulic oil or gas.
5.3 Important additional user information
To Next Page
Loading...