HOLT HI-3110 - User Manual

AN-175 Rev. B Holt Integrated Circuits
ADK-175 User’s Guide –
HI-3110 Evaluation Board
April 2020

Summary

Board Setup and Configuration

Demonstration Set-up

Provides a block diagram and description of the evaluation board's setup.

CAN BUS Bit Rate and Mode Selection

Details configuring bit rate and operating modes using DIP switches.

Switch Functions and Serial Port Configuration

Explains OPT1, OPT2 switches, buttons, and serial port setup.

Hardware Interfaces and External Connections

External MCU;FPGA and Dual Voltage Configuration

Instructions for integrating with external MCU/FPGA and setting up dual voltage.

User Guide - Operating Modes

Mode-1: Transmit Mode Standard Frames

Transmits standard CAN frames with incrementing data.

Mode-2: Receive Mode using Polling

Receives CAN frames using a polling method and checks data frames.

Advanced Operating Modes and Features

Mode-4: LoopBack Mode

Combines transmitter and receiver functions for loopback testing.

Mode-5: Transmit Extended Frames

Mode-6: Receiver Interrupt Mode

System Flow and Interrupts

Receiver Mode Flow Charts

Transmitter Modes Flow Chart

MCU and HI-3110 Technical Details

Advanced Features and Tools

Filtering on ID

Freescale Development Tools

Information on using CodeWarrior and related development tools.

Codewarrior Project Setup

Details loading the HI-3110 project with Codewarrior IDE.

HOLT HI-3110 Specifications

General

Manufacturer	HOLT
Model	HI-3110
Category	Motherboard
CPU Socket	LGA 1151
Memory Type	DDR4