25
CLEANING AND STORAGE
TROUBLESHOOTING
•Parts of the appliance (nozzles, bowls, etc.) that have direct contact with the food must be cleaned
every time aer using the appliance.
WARNING!
•All plastic parts and accessories should be washed in warm water with a dishwashing detergent, then
rinsed and dried.
Do not wash parts of the appliance (nozzles, graters, etc.) in a dishwasher.
•It is recommended to wipe the body of the appliance with a damp cloth.
•Cutting metal accessories should only be washed in cold water to prevent premature blunting of the
blades. Then the metal nozzles must be wiped dry.
Before each cleaning or maintenance, remove the plug from the electrical socket.
•If necessary, turn on the «protection from children» system by clicking on the button below on the
back of the body of the food processor.
CLEANING AND STORAGE
Shelf life until implementation is unlimited.
TROUBLESHOOTING
1. The appliance is not plugged
into the mains supply.
2. No electricity.
3. On/off button is not
pressed.
The appliance does
not turn on
1. Plug the appliance to the mains supply.
2. Check fuse or circuit breaker.
3. Press the on/off button.
1. Overload of the bowl,
overload of grinding head
with food, wound of fibers
around the feed screw.
2. Overheat of the motor.
The appliance has
stopped working
during use.
2. Take a break from work and let the motor rest for
30 minutes.
Do not exceed the maximum continuous operating
time. When working with a large amount of food,
follow the interval between switching on/off the
appliance.
1. Unplug the appliance from the mains supply.
Disassemble the appliance. Free the bowl, the
grinding head from excessive amount of food, free
feed screw from the fibers, cut the food into small
pieces according to the instructions, if necessary.
CauseProblem Solution
1 Unplug the appliance from mains supply and make
sure that the appliance is assembled properly.
2. Place the appliance on a flat hard surface.
Abnormal noise
or strong
vibration during
operation of the
appliance
1. Detachable parts are not
fitted properly or not fixed.
2. The appliance is mounted
on an uneven or unstable
surface.
IMPORTANT! If none of the above measures resolve the problem, contact an authorized
service center.
To Next Page
Loading...