What to do if the spindle does not rotate on my HOLZMANN MASCHINEN ZX40PC Drill?
If the spindle of your HOLZMANN MASCHINEN Drill isn't rotating, there could be several reasons. First, the mains connection may be incorrect, which requires a specialist to check it. Second, the switch might be damaged, so you should check and repair the switch. Lastly, the motor could be damaged, requiring a check and repair.
How to fix strong vibrations in my HOLZMANN MASCHINEN Drill?
If your HOLZMANN MASCHINEN Drill is vibrating strongly, it might be due to a couple of reasons. First, check if it's standing on uneven ground and realign it if necessary. Second, the motor fastening might be loose, so try tightening the screws.
What to do if my HOLZMANN MASCHINEN ZX40PC Drill has incorrect rotation?
If your HOLZMANN MASCHINEN Drill is rotating in the wrong direction, the switch knob may be indicating the wrong direction. Change it to the correct position.
Why is the spindle not reaching full speed on my HOLZMANN MASCHINEN ZX40PC Drill?
If the spindle of your HOLZMANN MASCHINEN Drill isn't reaching the correct speed, there are a few potential causes. It could be that the extension cable is too long, in which case you should exchange it for a shorter one. Alternatively, the motor might not be suitable for the existing voltage; check the switch box cover for correct wiring. Finally, there may be problems with the mains, and you should contact an electrical specialist.
General| Drilling Capacity in Steel | 40 mm |
|---|---|
| Drilling Capacity in Cast Iron | 40 mm |
| Spindle Taper | MT4 |
| Number of Speeds | 12 |
| Motor Power | 1.5 kW |
| Voltage | 400 V |
| Frequency | 50 Hz |
| Spindle Travel | 120 mm |
| T-slot size | 14 mm |
| Spindle stroke | 120 mm |
| Column diameter | 115 mm |
To Next Page
