Holzmann BT 46ECO - Assembly; Delivery Content; Disc Sander (Fig.a); Worktable (Fig.b)

HOLZMANN MASCHINEN Austria www.holzmann-maschinen.at Strana 33
TALÍŘOVÁ A PÁSOVÁ BRUSKA / BELT AND DISC SANDER BT 46ECO
13 ASSEMBLY
13.1 Delivery content
The machine is delivered pre-assembled.
For transport reasons, some parts of the machine can be assembled by the customer.
BT 46ECO
Machine
Table
Fence
Table support
Hex-nut-driver
Safety fence
User manual
Sanding belt and disc
Operating tools
Screws
Check right after receiving the machine, whether all parts according to the parts list are complete and
without damage. Each visible defect and in particular wrong amounts and transport damages must be
clearly noted on the delivery documents, otherwise the goods shall be considered as taken over and
fully accepted under the sole responsibility of the customer.
13.2 Assembly
13.2.1 Disc sander (fig.a)
 Fit the feet (2) to the underside of the machine.
 Fit the protective cover to the shaft.
 Secure the protective cover with three screws.
 Fit the disc sander to the shaft.
 Tighten the disc sander using the Allen key.
 The sand paper sheets are affixed using hook and eye tape connections. Align the sand
paper sheet carefully and press firmly onto the disc sander.
 Secure the lower disc protector with four screws
13.2.2 Worktable (fig.b)
 Fit the bolt (15) into the table support (3). To avoid the trapping of fingers or workpieces
between table and grinding wheel, the distance between table and grinding wheel may be
max.2mm!
 Tighten the fixing screw using the Allen key.
 Push the angle stop (6) into the guide groove (16) of the worktable (5) (fig.c).