Holzstar DB 450 - Default Chapter; Imprit; Content; Table of Contents

2 Four-jaw Chuck | Version 1.02
Imprit
Produktidentifikation
Four-jaw Chuck Item number
Ø 100 mm M33 x 3,5, Set 2 5931023
Manufacturer
Stürmer Maschinen GmbH
Dr.-Robert-Pfleger-Str. 26
D-96103 Hallstadt
Fax: 0049 (0) 951 96555 - 55
E-Mail: info@holzstar.de
Internet: www.holzstar.de
Indications regarding the operating instructions
Original operating instructions
Edition: 22.03.2023
Version: 1.02
Language: English
Author: MS/FL
Indications regarding the Copyright
Copyright © 2023 Stürmer Maschinen GmbH, Hallstadt,
Germany.
The contents of these operating instructions is the sole
property of the company Stürmer Maschinen GmbH.
Passing on as well as copying of this document, the use
and distribution of its content are prohibited if not expli-
citly permitted. Contraventions are liable to compensa-
tion.
Subject to technical modifications and error.
Content
Imprit........................................................ 2
Content .................................................... 2
1 Introduction ............................................. 3
1.1 Copyright ............................................................ 3
1.2 Customer service................................................ 3
1.3 Limitation of liability............................................. 3
2 Safety ....................................................... 3
3 Intended Use ........................................... 4
4 Technical Data......................................... 4
5 Transport, packaging, storage............... 4
5.1 Delivery and Transport ....................................... 4
5.2 Packaging........................................................... 4
5.3 Storage ............................................................... 4
6 Description of device.............................. 4
7 Assembly and Operation........................ 5
7.1 Mounting and securing the chuck to the wood
lathe spindle....................................................... 5
7.2 Changing the chuck jaws.................................... 5
7.3 Clamping a workpiece in the chuck .................... 5
7.4 Removing the adapter ........................................ 5
8 Disposal, recycling of old equipment ... 6
8.1 Decommissioning ............................................... 6
8.2 Disposal of lubricants.......................................... 6
9 Spare parts .............................................. 6
9.1 Spare parts order................................................ 6
9.2 Spare parts drawing............................................ 7