1. As shown in the figure:
- Insert rear wheel to the main frame. Tap
gently until the sound of click.
2.As shown in the
picture, fix the front
fender onto the front fork
using screws.
3.As shown in the figure:
- Insert the front wheel
into the front fork, tighten
the bolt and nut.
4.As shown in the picture, first insert the
front wheel assembly into the main frame,
then fit the front cover into the handlebar
opening, and then insert the handlebar
opening into the fork's upper opening,
aligning the fork screw hole with the
handle screw hole. Insert the handlebar
fixing screw through the opening; then,
using a socket wrench, tighten it and
lower the front cover. Finally, install the
bell on the handlebar.
5.As shown in the picture, first unscrew the nut at the
rear end of the steering rod, then insert the front end of
the steering rod vertically into the front fork hole a, lay
the steering pipe flat, ensuring a secure connection
with the front fork hole; twist the lower push tube to
align the push tube hole b so that the rear end of the
steering rod can be hooked into the hole; once hooked,
secure it with a nut.
a
b
Tips from the following picture
Twist the push rod ,and adjust it to
the hole(b)
Tips from the following picture
Insert into hole ( a) and lay the steering
rod flat
7
To Next Page
Loading...
Need help?
General
