E
1. Remove all of the contents from inside the packing
and place them on a clean flat surface. Check all the
contents according to the parts list above. Check all
contents for damage.
2.Set the wheels to one side and remove any
protective plastic caps from the ends of the axles.
3.Assemble the canopy frame.
4.Lift each bar of the trailer body until the trailer is
fully erect.
To provide more comfort, the sling seat can be
adjusted by pulling on one or both sets of the seat.
Loosen the straps to allow the trailer to fold flat.
Attention !
The sling seat should not be adjusted too tight.
Assembly of the wheels
1.Locate the rear wheel brackets on each side of the
trailer and read the warnings carefully.
2.Push one wheel axle completely through the
bracket hole until you hear the axle click into place.
Danger !
Pull firmly on each wheel to ensure the locking
mechanisms are securely engaged!
Push to unlock
To Next Page
Loading...
