Home Decor Basswood User Manual (English)

To Next Page

2612 West Townley Ave, Suite 5, Phoenix, AZ 85021

Phone: 602-995-9659 Fax: 602-995-7157

HII-1

Revision 110420

Made in America

2” and 2 1/2” Basswood and Fauxwood

Installation Guidelines

You will need:

Pencil, tape measure, drill, screwdriver, pliers, and appropriate fasteners

Choose the Correct Fastener

1 1/2” #8 hex head wood screws (included). Alternative fasteners should be used for metal,

brick, tile, concrete or other material installations

(not included in HOME DECOR hardware

package).

Prepare Brackets

Use the following number of center support installation brackets based on the blind width:

Up to 63”

63” - 84”

Greater than 84”

Open the front of the bracket by pressing on the

bottom of the bracket to release the locking tab,

while lifting the front gate.

Need help?

Do you have a question about the Home Decor Basswood and is the answer not in the manual?

Home Decor Basswood Specifications

General

Select appropriate fasteners, including included hex head screws or alternatives for different mounting surfaces.

Determine the number of center support brackets needed based on blind width and learn how to open the bracket.

Position and mark bracket mounting holes for outside and inside mounts, ensuring they are square and level.

Screw brackets into the wall or window frame for secure mounting.

Attach valance clips to the headrail and then the valance itself.

Align and slide the headrail into the installed brackets until snug.

Drill into the bottom rail and attach hold-down brackets for stability.

Instructions on using the cord to lower and raise the blind, and how to lock it.