Wir
eless Push Buttons
ITEM #206 049 303,#1001 406 887,
MODEL #216592,
#216593,
#216594, & #216595
Installation
1
ACTIVATING THE PUSH BUTTON BATTERY
□ Remo
ve the front cover of the push button by inserting a flat
head screwdriver in the slot on the bottom of the button and
pulling up slightly.
□ Remo
ve the plastic tab from the battery compartment to
allow connection to the terminal.
□ Snap the front co
ver onto the base by first hooking the tops
together, then snapping the base on.
□ Repeat for second button if applicable
.
2
POWERING THE CHIME
□ Install the c
hime batteries or plug in the chime, following the
instructions included in the chime.
3
SYNCING THE CHIME AND PUSH BUTTON
□ Follo
w the instructions included in the chime.
4
MOUNTING THE PUSH BUTTON
□ Remo
ve the front cover from the base by following step 1.
□ Mount the push button base to a clean w
all or door jamb
with included screws or mounting tape. If mounting with
screws, predrill a pilot hole through the push button base in
the desired location using a 5/64 in. drill bit.
□ Snap the push button co
ver onto the base by first hooking
the tops together, then snapping the base on.
To Next Page
Need help?
General