13
HOW TO SELECT A WASH PROGRAM
How Do I Change the Wash Program?
You can change your wash cycle only if it has been running for a short time and the detergent has not yet been
To change the wash program, press and hold the program button for more than three seconds. The machine will enter
standby mode where you can then change the setting. See “How Do I Select a Wash Cycle?” for instructions.
The lights will show the state of the dishwasher:
a) All phase lights off On stand by
b) The display light steady (not blinking) Paused
c) The display light blinking Running
You can add a dish at any time before the detergent is dispensed. To do so:
1. Press the start/pause button.
2. Crack the door open to stop the wash cycle.
3. Once the spray arms stop moving, open the door completely.
4. Add your dishes to the basket.
5. Close the door.
6. Press the start/pause button again and the dishwasher will run after ten seconds.
What Do I Do Aer the End of the Cycle?
to turn the dishwasher off. Shut off the water supply and open the door. Wait a few minutes before handling your
dishes to allow them to dry and become less susceptible to damage. The dishwasher will automatically enter
standby mode, then turn off after 30 minutes.
How to Turn off the Dishwasher
The program has ended when all of the phase lights are off. Then:
1. Press the power button to turn the dishwasher off.
2. Turn off your water tap.
Note: Open the Door Carefully
Hot dishware is senstive and can break easily. Allow to cool for at least 15 minutes before removing from the dishwasher to
prevent damage.
To do this, crack open the dishwasher’s door open and leave it ajar for a few minutes. This will allow your dishware to cool
and dry.
How to Unload the Dishwasher
Note that it is normal for the dishwasher to be wet inside.
WARNING! It is dangerous to open the door when washing, because hot water may scald you.
OPERATING INSTRUCTIONS
To Next Page
Loading...
