10 11
CAUTION
PREPARE AIR CONDITIONER
INSTALL THE ACCORDION PANELS
bench or a table. Hold the
Accordion Panel in one hand
and gently pull back the
center to free the open end.
See Fig. 1
C: Align the hole in the top rail with those in the top of
the unit as shown in Fig. B.
Fig. B
D: Secure the top rail to the unit with the 3/8” Screws
as shown in Fig. C.
Fig. C
A: Remove the air conditioner from the carton and
B: Remove top rail from the rear of the packaging
material as shown in Fig. A.
Top Rail Hardware
Fig. A
or
3/8” Screws (x4)
Top Rail (x1)
Top Rail
Top Rail
Installation Instructions
Note: For safety reasons, all four (4) screws MUST be
securely fastened.
Note: Top rail and Sliding Panels at each side are
offset to provide the proper pitch to the rear of
(5/16). This is necessary for proper condensed water
utilization and drainage. If you are not using the
Side Panels for any reason, this pitch to the rear
must be maintained.
B. Slide the free end “I” section of the panel directly into
the cabinet as shown in Fig. 2. Slide the panel down. Be
sure to leave enough space to slip the top and bottom of
the frame into the rails on the cabinet.
Fig. 2
“ ” section”
Fig. 1
SECURE THE ACCORDION PANELS
place the unit into the window opening so the
bottom of the air conditioner frame is against the
window sill (Fig. 5). Carefully close the window
behind the top rail of the unit.
Wooden Windows
OUTSIDE
INSIDE
About 5/8” to 3/4”
FOAM SEAL
C. Once the panel has been installed on the side of
the cabinet, make sure it sits securely inside the
frame channel by making slight adjustments. Slide
the top and bottom ends of the frame into the top
and bottom rails of the cabinet (Fig. 3).
Fig. 3
Top Rail
Bottom Rail
D. Slide the panel all the way in and repeat on the
other side (Fig. 4).
Fig. 4
Bottom mounting rail
Top left
A. Place the frame lock between the frame extensions
and the window sill as shown (Fig. 7). Drive 3/4” or 1/2”
locking screws through the frame lock and into the sill.
Fig. 7
B. Drive 3/4” or 1/2” locking screws through frame holes
into window sash (Fig. 8).
Fig. 8
B. Extend the side panels out against the window
frame (Fig. 6).
window frame
Installation Instructions
INSTALL SUPPORT BRACKET
Note: Check that air conditioner is tilted back
about 5/8” to 3/4” (tilted about 3 to 4
downward to the outside). After proper
installation, condensation should not drain
use, correct the slope otherwise.
Note: To prevent window sill from splitting,
drill 1/8” pilot holes before driving screws.
Note: If storm window blocks AC, see Fig. 11.
To Next Page
Loading...
