Home HME020437N - Operation - Setup and Control; Appliance Placement; Control Panel Functions; Powering On;Off

9
Operation
PLACE THE APPLIANCE
- This unit may have been
tilted or placed upside down
during shipping. To ensure
this device works properly,
please ensure this unit is
upright for at least 24 hours
before initial use.
- This dehumidier is designed
to operate with a working
environment between 41°F
(5°C) and 90°F (32°C).
CONTROL PANEL
DRAIN CONT.
FULL CONT. DEFROST TIMER
POWERTIMER
INCREASEDECREASE
To turn on / off the appliance
• Plug in the appliance, the screen will light up. Press POWER button, the unit will start working
in continuous mode. The screen displays the environmental humidity. The compressor will start
to work 3 seconds after the fan starts working.
• To turn off the appliance, press POWER button, the screen displays “- -” and the appliance goes
into standby mode. The fan will run for another minute before stopping.
To set the timer
• Press TIMER button while the appliance is off, the timer indicator will light up. Press DECREASE
or INCREASE button to set the time to start the appliance. When the countdown is over, the fan
and the compressor will turn on.
• Press TIMER button while the appliance is running until the timer indicator lights up. Press
DECREASE or INCREASE button to set the time to turn off the appliance. When the countdown
is over, the fan and compressor will shut off.
• To display the current temperature, press and hold TIMER button for 3 seconds. After 10 seconds,
the screen will display current humidity.
more than 11.8 in (30cm)
more than 11.8 in (30cm)
more than 11.8 in (30cm)
more than 11.8 in (30cm)
more than 11.8 in (30cm)