8
OPERATION
Energy Conservation
• The cooler should be placed in a room that is dry and ventilated. The cooler cannot be placed under direct
sunlight or next to a heat source (such as a radiator, stove, etc.), and a suitable insulation board must be
applied if necessary.
• Try to shorten the opening time of cooler’s door.
• Avoid putting warm beverages in the cooler.
PROPER USE OF BEVERAGE COOLER
INTRODUCTION TO THE BEVERAGE COOLER’S FUNCTIONS
-Display Controls
tone will ring.
-Standby Mode
To activate standby mode, hold the standby button for 3 seconds. You will hear a beep and the display area will be
cut off. To deactivate standby mode, press the button again. You will hear a beep and the standard display will show.
-Lighting
Press the lighting button to turn the light on or off.
-Temperature Seing
Press the increase temperature button to increase the temperature one degree at a time. Press the decrease
temperature button to decrease the temperature one degree at a time. To change display from F to C, press and
hold the increase and decrease button simultaneously for 5 seconds.
-Memory Function
If turned off, this cooler will remember any settings in place and will work according to those settings once it’s
turned on again.
-Fault Indicators
If any of these indicators are displayed, it means the cooler has the following issues.
E1 R room sensor failure
R room defrost sensor failure
FAULT CODE DESCRIPTION
E4
Installation
• Keep in upright position for 24 hours before initial power up.
• While the cooler is empty, set the Temperature Control to maximum and leave for 1 hour.
• When you start putting beverages inside the cooler, maintain a 4 cm gap between the interior wall of the
• Follow steps below if you want to change the door orientation from left-hinge to right-hinge:
1. Use a screwdriver to remove upper and lower left hinge (triangle with 3 screws).
2. Transfer the hinge to the right of the cooler and attach to the right side of the door.
To Next Page
Loading...