8 9
INSTALLATION INSTRUCTIONS
UNPACKING AND REMOVING SHIPPING MATERIAL
Remove the packing box and lift the washer up and away from the foam base cushion. Open the lid of washer to take out
all accessories including protection foam.
Foam base cushion
Protection foam
Parts Description
Top lid
Control panel
Frame
Cabinet
Adjustable leg
Top lid
Water inlet
Power line
Drain hose
Roller
Pump filter
(The only one)
Accessories
Owner's mannual Water supply hoses
Quick connection adaptor Bottom cover
Screw
Straps
*Please find this part on
the top foam in the box.
Tools Needed in Installation
levelPliers
Phillip screwdriver
Key Dimensions and Specications
17.7in.
450mm
31.5in.
800mm
41.3in.
1050mm
min 1in.
25mm
min 1in.
25mm
CHOOSE THE PROPER LOCATION
IMPORTANT: Make sure to follow the electric and grounding requirements and warning in Important Safety
Instructions.
Floor
For best performance, you must install your washer on a solidly constructed oor. Wood oors may need to be
reinforced to minimize vibration. Carpeting and soft tile surfaces are contributing factors to vibration which can cause
your washer to move slightly during the spin cycle.
WARNING: Do not install your washer in areas where water may freeze, since your washer will always retain some
water in its water valve, pump, and hose areas. Frozen water can damage the belts, the pump, hoses, and other
components. Never install on a platform or weakly supported structure.
INSTALLATION INSTRUCTIONS
To Next Page
Loading...