ENGLISH
9
PREPARE THE INSTALLATION
Ensure the power has been turned o before beginning this installation.
Plug must be assembled in places easy to drag and insert.
To install this hood you will require two assistants. Tools you will need:
• Drill
• Phillips Screwdriver
• Tape Measure
NOTES:
• Installation work and electrical wiring must be done by qualied person(s) in accordance
with all applicable codes and standards, including re rated construction.
• Do not discharge the exhaust air into a fuel from other appliances burning gas or other fuels.
• Regulations concerning the discharge of air have to be fullled.
• The cooker hood must be placed at a minimum distance
of 65cm above the cooking surface of a hob.
• The cooker hood must be placed at a maximum distance
of 75cm above the cooking surface of a hob.
CUPBOARD MOUNTING INSTALLATION
• Drill a 130mm diameter and four 3.5mm diameter hole as below picture. ATTENTION: If your
cooker hood works at circulating-air mode, it is not necessary to drill 130mm diameter hole.
• Use the 4 screws to x the cooker hood to a kitchen cupboard .Check that
your xings are correctly located, by temporarily tting the cooker hood.
If correct, t the unit into position. Tighten the screws if necessary.
To Next Page
Loading...