ENGLISH
7
HOW TO OPERATE
NOTE: This appliance is for indoor use only. Appliance is not
recommended for use in a garage or basement.
Before rst use, clean your ELECTRIC WINE COOLER by removing the shelves and rinsing
the cabinet with soda water, then rinsing with clean water. Use a slightly damp, non-
abrasive sponge, towel or cloth to wipe down the inside and outside of the Main Unit,
then wipe with a non-abrasive towel to dry. Wipe down shelves and put back in place.
1. After cleaning, nd a at surface near an electrical outlet that is away from direct sunlight,
all sources of heat, and any water source. Allow unit to stand upright for approximately
2 hours before connecting to the power source. This will reduce the possibility of a
malfunction in the cooling system from handling during transportation. CAUTION:
Please keep appliance away from ammable substances, which can cause ignition.
2. Plug unit in, then locate the temperature arrow key buttons on each cabinet
door. The temperature is pre-adjusted to be within the range of 51° to 64°F (11°C
to 18°C) for each cabinet. To change this preset, use the up and down arrows.
To change from Fahrenheit to Celsius, press both arrows at the same time.
NOTE: Unit operates best when ambient temperature is around mid-70°F.
3. Once the unit is plugged in, the cooling system will begin to work. When the
interior temperature reaches your selected preset point, the cooling system
will go into half-power mode to keep the temperature constant.
To Next Page
Loading...
Need help?
General