HoMedics MCS-1200H - User Manual

MCS-1200H Assembly Instructions
Note: This chair requires 2 adults to properly assemble.
Locate the seat cushion and back cushion. Align the metal rings and push 1 metal
plug through each hole. Next, locate the 2 metal pins, and insert into the small hole
in each metal plug.
Locate the wooden dowels, wooden legs and support planks. Insert 1 dowel into
each of the pre-drilled holes on the short edge of the wooden planks. Then attach
the planks to the legs by aligning the dowels with the pre-drilled holes on the legs
and pushing in until the pieces are flush.
Locate the long screws and the metal nuts. Drop 1 metal nut into each pre-drilled
hole on the support planks. Next, twist the long screws into the holes on each side of
the wooden legs, until they reach the metal nut. Ensure the hole in the metal nut is
aligned with the screw. Use the Allen wrench to tighten. The screw should be almost
flush with the wooden leg when tightened.
STEP 1
STEP 2 STEP 3
1
2
3
4
5
6
7
8
9
10
11
12
STEP 4 STEP 5
1 2
3
4
5
9
10
6
11
6
8
6
Place the seat and back cushion between the 2 wooden legs. Locate the short
screws and twist into each of the 4 holes on the wooden legs. Each screw will go
completely through the hole in the wooden leg and enter the hole in the side of the
back or seat cushion. Using the Allen wrench, ensure that the screw is tightened
and that there is no space between the cushion and the wooden leg. Plug in your
chair, and enjoy a massage with or without the intensity control flap attached.
7
Locate the following pieces:
Back cushion (1)
Seat cushion (1)
Wooden legs (2)
Wooden support planks (2)
Intensity control flap (1)
Long screws (4)
Short screws (4)
Nuts (4)
Metal plugs (2)
Pins (2)
Wooden dowels (8)
Allen wrench (1)
6
7
8
9
10
11
12
11
9
10
8
11
6
8
7
11

Summary

MCS-1200 H Assembly Instructions

Step 1: Identify Components

Locate all the necessary pieces for chair assembly, including cushions, legs, planks, hardware, and tools provided.

Step 2: Connect Cushions

Align metal rings on seat and back cushions, insert metal plugs, and then insert metal pins into the plugs.

Step 3: Attach Support Planks to Legs

Insert dowels into support planks and attach them to wooden legs, ensuring alignment.

Step 4: Secure Support Planks

Insert nuts into support planks and use long screws to attach planks to wooden legs, tightening with Allen wrench.

Step 5: Final Assembly and Connection

Attach seat and back cushions to legs with short screws, then plug in chair for massage.

HoMedics MCS-1200H Specifications

General

Brand	HoMedics
Model	MCS-1200H
Category	Indoor Furnishing
Language	English