Homelite MightyLite UT08550 User Manual

Page 10
ASSEMBLY
INSTALLING THE VACUUM TUBES
See Figures 5 - 6.
WARNING:
Rotating impeller blades can cause severe injury. Always
stop the engine before opening the vacuum door or
installing/changing tubes. Do not put hands or any other
object into the vacuum tubes while they are installed on
the unit.
To install the vacuum tubes:

Place the unit on its side to allow easy access to the vacuum
door.

Secure the upper and lower vacuum tubes together by
aligning the raised locking tabs with the raised slots.

Align the screw holes in the lower tube with the raised slot in
the upper tube. Adjust the length and secure with supplied
screws.

Using a flathead screwdriver, rotate the screw securing the
vacuum door counterclockwise to release.

Place the lip on the upper vacuum tube beneath the hinge
of the vacuum door. This will allow the screw on the other
side to seat in the threaded hole.

Using a flathead screwdriver, tighten the screw to secure.

To remove the vacuum tubes, reverse the above steps.
Fig. 5
Fig. 6
vacuum
TubeS
ScRewScRew
vacuum
dooR
uPPeR
vacuum
Tube
hinGe
ThReaded
hole

Homelite MightyLite UT08550 Specifications

General

Brand	Homelite
Model	MightyLite UT08550
Category	Blower
Language	English