Page 7 — English
SYMBOLS
Some of the following symbols may be used on this product. Please study them and learn their meaning.
Proper interpretation of these symbols will allow you to operate the product better and safer.
SYMBOL NAME DESIGNATION/EXPLANATION
Safety Alert Indicates a potential personal injury hazard.
Read The Operator’s
Manual
To reduce the risk of injury, user must read and understand
operator’s manual before using this product.
Wear Eye and Head
Protection
Always wear eye protection with side shields marked to comply
with ANSI Z87.1, along with head protection.
Wet Conditions Alert Do not expose to rain or use in damp locations.
SAFE-T-TIP Nose Guard
The SAFE-T-TIP nose guard on the guide bar helps prevent
kickback.
Operate With Two Hands Hold and operate the saw properly with both hands.
One Handed Do not operate the saw using only one hand.
Kickback DANGER! Beware of kickback.
Bar Nose Contact Avoid bar nose contact.
Wear Gloves
Wear non-slip, heavy-duty protective gloves when handling
the chain saw.
Wear Safety Footwear Wear non-slip safety footwear when using this equipment.
Keep Bystanders Away Keep all bystanders and animals at least 50 ft. away.
V Volts Voltage
A Amperes Current
Hz Hertz Frequency (cycles per second)
W Watt Power
min Minutes Time
Alternating Current Type of current
Direct Current Type or a characteristic of current
n
o
No Load Speed Rotational speed, at no load
Class II Construction Double-insulated construction
.../min
Per Minute Revolutions, strokes, surface speed, orbits etc., per minute
To Next Page
Loading...
Need help?
General